How Decontamination Works
HOW IT WORKS - THE DECONTAMINATION PROCESS AND YOUR PART IN IT
Pacific Decontamination Services uses the world’s strongest, most effective and safe antimicrobial disinfectant, deodorization and chemical decontaminate. Our professional application will eliminate up to 99.9999%* of any allergen, germ, bacteria or fungus that it touches. AND as powerful as it is, it is also completely safe.
We come to your location. Depending on the job, we apply our formula by spray, mist, foam, or fog. We do not use a tent. The average time of our on-site service is approximately one hour. An additional four hours is required to achieve maximum effectiveness. We ask that you stay out of the vehicle or premise for approximately 5 hours in total.
Preparation
Vehicles/RV’s
We ask that you conduct a general cleaning of the vehicle including vacuuming and removal of obvious dirt and debris. We recommend that you replace the vehicle cabin air filter before our service. For RV's and trailers, remove obstructions from all floor vents, Also remove and replace all furnace and air filters. This will ensure the maximum opportunity to eliminate all odors. Cover or remove all plants. Do not try to mask odor by using air fresheners or fragrance.
After application, a slight residue on the interior windows will occur. Cleaning the interior windshield, side/rear windows, and general wipe down of the dash area is recommended.
Residences (Home, RV, Trailer)
Remove all pets, pet food bowls, plants, and cover all aquatic animal tanks. Cover or remove all plants and vegetation. Turn HVAC and recirculation fans off. Do not try to mask odor by using air fresheners or fragrance. Remove debris from all floor vents. Also remove and replace all furnace and air filters.
After application, we require an additional 4 hours of set time. Then remove coverings, and wipe down any food preparation surfaces with potable water. If you had bedbugs or other insects, they may now be dead. Vacuum and wipe areas as required.
Mold Inspection and Testing
Our initial on site inspection offers 7 type of mold testing. We use cutting-edge technology and industry-tested tools to reach unbiased conclusions during diagnostic initial inspections for mold, moisture, and other indoor contaminants. Click here
Bacteria Testing
Our bacteria testing and cleaning validation services is known as ATP monitoring. We use the most advanced, remote, cleaning verification technology in the industry. We test and real-time measure residual organic matter that is on a surface, device, or piece of equipment. ATP (Adenosine Triphosphate) is an enzyme that is present in all organic matter – living, or once living – including blood, saliva, and bacteria. We provide you with instant test results of the contamination level, which allows you to verify our work, or take corrective action in regards to your cleaning program and procedures.
How We Scientifically Measure Contamination
Click Here to View Types of Biological Organisms and Chemical Threats that Pacific Decontamination Kills and Neutralizes
*Log Kill data varies by organism, test data available on request.
Our product is tough enough to neutralize chemical and biological weapons, as well as all types of germs, yet is safer and gentler than common household bleach. It effectively neutralizes up to 99.9999%* of all bacteria, viruses, spores, germs, and chemical & biological hazards. The formula is non-flammable, non-corrosive, contains zero VOCs, and is biodegradable. It eliminates both vegetative and non-vegetative spores, by chemically cleaving spore walls, and neutralizing mycotoxins therein. We apply as a foam, fog, mist or direct spray, mopped, or even as a detergent. Used by RCMP, FBI, CIA, Secret Service, Dept. of Homeland Security, U.S. EPA, and FEMA. Leaves a non-toxic pH neutral residual barrier to prevent re-growth.